VBrick Systems 7000 manual Announce Settings

	Program Configuration
Destination	Select IP Address or Host Name from the dropdown.
	The actual IP address determines whether the stream
	will be multicast (e.g. 239.22.118.72) or unicast (e.g.
	127.22.118.72). Default = 127.0.0.1 (loopback).
	If using a Host Name, you must configure a Domain
	Name Server on the System Configuration > Network
	page.
Transport Type	• RTP – Default. Realtime transport protocol provides
	end-to-end network transport functions suitable for
	video.
	• Transport Stream – Multiplexes the digital video and
	audio into one bit stream.
Destination Video Port	Destination video port for this transmitter. Note that
	viewing a unicast and multicast stream (configured on
	different transmitters) on the same PC or the same
	decoder may not work if the transmitter ports are the
	same.
Destination Audio Port	Destination audio port for this transmitter.
Estimated Bit Rate	Read-only. This is an estimate. The actual bit rate will
	vary based on the content.
RTCP Transmit	Enable allows RTCP sender reports to be sent from the
	VBrick appliance. Default = Enable.
RTCP Transmit Interval	If RTCP Transmit is enabled, this setting tells the
	appliance how often (in seconds) to send the reports.
	Default = 10 seconds.

Announce Settings

This section contains parameters that are used to modify announcements from the appliance. Announcements are advertisement packets that are transmitted by VBrick appliances to other VBrick appliances and VBrick applications such as the EtherneTV Portal Server and StreamPlayer. They are used to identify streams present in the network.

VBrick H.264 Appliance Admin Guide 51