![](/images/new-backgrounds/1242477/242477121x1.webp)
Figure 9. Transmitters: Part 2 – Advanced Settings
Announce | This section is used to announce the RTSP streams to |
| the local network allowing viewable RTSP |
| announcements in programs like StreamPlayer. The |
| unit must be on the same segment of the network or |
| the router must be configured to retransmit broadcast |
| packets for the announcements to be accessible using |
| the IP address 255.255.255.255. |
|
|
Use Global Announce IP and Port | Use Announce IP Address for Transmitters and |
| Announce Port defined on Program Configuration > |
| Global page. If checked, the Destination and Port |
| fields are greyed out. |
|
|
Send to Unicast Destination | If enabled and the destination is unicast, the unicast |
| IP address is used for the announcement and the |
| Destination field is greyed out. Default = Disabled. |
|
|
Destination IP Address | The destination IP Address or Host Name the |
| announcement is sent to. By default, the |
| announcement is sent to the multicast network. If |
| using an EtherneTV Portal Server, enter the Portal Server |
| IP address. |
|
|
Port | The destination port the announcement is sent to. |
|
|
External Announce Settings
These settings configure an external announcement that can be used when the stream is reflected to a
52 | © 2009 VBrick Systems, Inc. |