Vermont Casting 1636, 1635, 1638 Install the Fan, Install the Rheostat Switch, Install Stove Legs

Vermont Castings Seville

Install the Fan

1.Position the Fan body within the Rear Shroud as shown in Figure 20. The Fan’s upper flange should be located behind the lip of the opening. Secure the Fan to the Shroud using five sheet metal screws and single star washer supplied with the kit.

Install the Rheostat Switch

1.Install the Switch within the Switch Bracket that is provided with the stove in the Hardware Bag. Use the Retainer Nut and Control Knob provided in the Fan Kit. (Fig.21-1)

2.Attach the Switch Bracket to the left side of the Rear Shroud using two sheet metal screws as shown in Figure 21-2.

3.Secure the fan wire harness to the back of the Shroud using the Wire Tie plug as shown in Figure 21-2.

Install Stove Legs

Install legs before removing the stove from the pallet. Use the four 1/4 -20x 1” hex head bolts with washers from the parts bag. The shoulder of the legs should seat within the locator tabs cast into the stove bottom at each corner. Tighten the bolts with the 7/16” wrench. CAUTION: Overtighening can strip tapped threads.

Pedestal Assembly

If you are using the Seville Pedestal option, assemble it before removing the stove from the pallet. Follow the assembly instructions included with the kit.

Insert Wire

Tie Plug

Here

		ST462
Fig. 21-2	Attach the Rheostat Switch and Wire Tie.
	1/4-20 X 1” Leg
	Bolt and Washer
	Leg Leveller	ST466

Remove the Stove from the Pallet

Caution. The Seville is very heavy. Do not attempt to handle the stove without assistance.

Carefully lift the stove off of the pallet and manuever it as close as possible to its final position.

Install the Bottom Heat Shield

The #1889 Bottom Heat Shield must be used in the U.S. and Canada in any installation on a floor that is not comprised of unpainted cement on earth. It is not required for use with the Pedestal option.

1.Remove the 1/4-20x 1/2" phillips screw from the central mounting boss in the stove bottom. (Fig. 23)

2.Mount the bottom heat shield to the stove bottom using the same phillips head screw previously re- moved. The corners of the shield will butt against the cast leg locators at each corner of the stove bottom.

Fig. 22 Attach the Stove Legs and Leg Levellers

1/4-20 x 1/2” Pan Head Screw

ST465

Fig. 23 Attach the Bottom Heat Shield to the boss in the center of the stove bottom.

30001490 15