Vermont Castings Madison
Install the Outside Air Adapter
The optional #1891 Outside Air Adapter provides a collar to which a 3” diameter air duct may be attached directly to the air inlet area at the back of the stove. This option can be installed in two different configura- tions, with Rear Heat Shield #1893 and without the heat shield.
With Rear Heat Shield
1. | Engage the Adapter against the Air inlet opening in |
| the Rear Heat Shield. Align clearance holes in the |
| adapter with pilot holes in the Rear Heat Shield as |
| shown at the bottom of Figure 26. |
2. | Use two sheet metal screws provided in the kit to |
Without Rear Heat
Shield
Stove Back
Outside Air
Standoff
Outside Air
Adapter
Primary Air Flap
With Rear Heat Shield
attach the Adapter to the Rear Heat Shield at the |
aligned holes. |
Without Rear Heat Shield
1. Facing the rear of the stove, loosen the pan head |
screw located a the upper left hand corner of the |
primary air inlet two revolutions. Position the Adapter |
over the air inlet opening in the rear of the stove with |
the pan head screw passing through the slotted tab |
in the Standoff. Make certain that the damper tab is |
ST462
Rear Heat
Shield
Oustide Air Adapter
located between the stove and the standoff and is |
oriented as it was before the screw was loosened. |
Tighten the pan head screw using the access hole |
in the standoff. The Thermostat and Primary Air Flap |
should operate freely. |
2. Engage the Adapter against the air inlet opening in |
the Outside Air Standoff. Align clearance holes in the |
adapter with pilot holes in the Standoff as shown at |
the top of Figure 26. |
3. Use two sheet metal screws provided in the kit to |
attach the Adapter to the Outside Air Standoff at the |
aligned holes. |
Fig. 26 Outside Air Adapter options.
Attach the Chimney Connector
Insert the crimped end of the first section of chimney connector into the flue collar. Using the holes in the collar as guides, drill 1/8” (3mm) holes through the connector pipe. Use the three #10 x 1/2” sheet metal screws provided to secure the chimney connection to the flue collar.
If applicable, attach Chimney Connector Heat Shields following the instructions included with those parts.
16 | 30001453 |
