Vermont Castings Intrepid
Assembly
Clean the Griddle Before Use
At the factory we coat the griddle with vegetable oil to prevent rusting while the stove is in transit and storage. Remove the oil with a dry rag or paper towel before you use the stove.
Set Up the Stove
Remove the griddle, front grate bar, the bottom grate, the side bricks, and the ash pan from inside the stove. Place a protective pad on the floor, arrange some sec- tions of 4 x 4 lumber on the pad for support, and care- fully tip the stove back onto them.
Remove and discard the four large
Slotted |
|
Screws | |
| ST513 |
Fig. 26 | Remove the slotted screws from the stove bottom. |
Install the Bottom Heat Shield
To install the bottom heat shield, loosen the leg bolts, and slip the bottom heat shield
Storing the Handle
Use the removable handle to open or close the front doors, or to change the position of the damper. After use, remove the handle so it will not get hot, and store it in the handle holder installed behind the right front leg. (Fig. 28)
10³⁄₄"
9³⁄₄"
ST512
Fig. 27 Attach bottom heat shield.
Door Handle Holder
Bottom Heat Shield
Bracket
Wing Bolt | ST514 |
Fig. 28 Handle holder and heat shield positions.
Reversing the Flue Collar
You can reverse the flue collar by removing the two screws that attach the collar to the back of the stove, as in Figure 29. Be sure the gasket around the flue collar opening is in position when you screw the collar back on to the stove.
Attach the Griddle Handle
Install the handle on the griddle. Place the griddle upside down at the edge of a flat surface and assemble the handle as shown. (Fig. 30)
With the handle pointing 45° from its final position, tighten the nut as far as possible with pliers. Move the handle to its final position while still holding the nut with the pliers.
2000970 | 17 |