Vermont Castings Intrepid
Installation
SAFETY NOTICE: IF YOUR STOVE IS NOT PROP- ERLY INSTALLED, A HOUSE FIRE MAY RESULT. TO REDUCE THE RISK OF FIRE, FOLLOW THE INSTALLATION INSTRUCTIONS. CONTACT LOCAL BUILDING OR FIRE OFFICIALS ABOUT RESTRIC- TIONS AND INSTALLATION INSPECTION REQUIRE- MENTS IN YOUR AREA.
Before you begin an installation, review your plans to see that:
•Your stove and chimney connector will be far enough from combustible material to meet all clearance requirements.
•The floor protector is large enough and is con- structed properly to meet all requirements.
•You have all necessary permits from local author- ities.
Your local building official is the final authority for ap- proving your installation as safe and determining that it meets local and state codes.
The metal label permanently attached to the back of every Vermont Castings stove indicates that the stove has been tested to current ULC standards, and gives the name of the testing laboratory. Clearance and in- stallation information also is printed on the label. When the stove is installed according to the information both on the label and in this manual, local authorities in most cases will accept the label as evidence that the installa- tion meets codes and can be approved.
However, codes vary in different areas. Before starting the installation, review your plans with the local building authority. You local dealer can provide any additional information needed.
For any unresolved installation issues, refer to CSA
IMPORTANT: FAILURE TO FOLLOW THESE IN- STALLATION INSTRUCTIONS MAY RESULT IN A DANGEROUS SITUATION, INCLUDING A CHIMNEY OR HOUSE FIRE. FOLLOW ALL INSTRUCTIONS EXACTLY, AND DO NOT ALLOW MAKESHIFT COM- PROMISES TO ENDANGER PROPERTY AND PER- SONAL SAFETY.
Outside Air
In some modern,
When poor draft is caused by a low infiltration rate, opening a ground floor window on the windward side of the house and in the vicinity of the stove will usually alleviate the problem.
Another solution is to install a permanent outside air supply to the stove and/or room. In some areas, in fact, bringing air for combustion from outside the home directly to the air inlet of the stove is required for new construction.
An outside air supply is not affected by pressure varia- tions within the house, and improved stove perfor- mance often results. An Outside Air Adapter Kit #33258 for the Intrepid II is available from your local Vermont Castings dealer.
What Kind of Chimney to Use
Your Intrepid
Aprefabricated
lated chimney
A
ST241
Fig. 2 Standard chimney types.
4 | 2000970 |