Vermont Casting NV360 Operating Instructions, Glass Information, Louvre Removal, Glass Cleaning

Models: NV360 NV580

1 28
Download 28 pages 37.6 Kb
Page 10
Image 10
Operating Instructions

NV360/580 Series

Operating Instructions

Glass Information

Only glass approved by CFM Corporation should be used on this fireplace.

The use of any non-approved replacement glass will void all product warranties.

Care must be taken to avoid breakage of the glass.

Do not operate appliance with glass front removed, cracked or broken.

Replacement glass (complete with gasket) is available through your Majestic Fireplaces dealer and should only be installed by a licensed qualified service person.

Louvre Removal

Glass Frame Glass Information

Fireplace

Front

Clamps

Glass

Panel

Glass

Panel

Louvre RemovalPull Clamp

Hook

Push Clamp

Handle

FP771a

Fig. 10 Glass panel removal.

To remove the louvre assembly top, pull louvre up, then lift out. (Fig. 9) The bottom louvre assembly is hinged at the bottom edge and swings down.

2. Glass Cleaning

Window Frame Assembly Removal Louvre

1.Assembly

Top

Glass Panel

FP444

Glass Cleaning

It will be necessary to clean the glass periodically. During start-up, condensation, which is normal, forms on the inside of the glass and causes lint, dust and other airborne particles to cling to the glass surface. Also, initial paint curing may deposit a slight film on the glass. It is therefore recommended the glass

be cleaned two or three times with a non-ammonia household cleaner and warm water (gas fireplace glass cleaner is recommended). After initial use the

Fig. 9 Remove louvre assembly top.

Window Frame Assembly Removal

1.Shut off gas.

2.Allow the fireplace to cool if it has been operating.

3.Remove louvre assembly top. (Refer to Louvre Re- moval, Fig. 9)

4.Open the bottom louvre assembly.

5.Release the two (2) clamps at the bottom of the win- dow frame by pulling down on the clamp handles.

6.Lift off the window frame assembly as shown. (Fig. 10)

7.To reinstall window frame assembly, follow the above procedure in reverse.

glass should be cleaned two or three times during each heating season depending on the circumstances present.

Clean glass after first two weeks of operation.

Do not clean glas when hot. Do not use abrasive cleaners. Do not strike or slam the glass.

Log Installation

Logs

NV360

NV580

Log Front Left

B25

E1

Log Front Right

B26

E2

Log Rear

B27

E3

Log Top Left

B28

E4

Log Top Center Left

--

E5

Log Top Center Right

--

E6

Log Top Right

B29

E7

10

20003565

Page 10
Image 10
Vermont Casting NV360 Operating Instructions, Glass Information, Louvre Removal, Glass Cleaning, Log Installation, Logs