Vertical Communications DX-80TM manual Headset Mode, Headset Enabled, Headset Disabled

4.2. To program a feature code, press [ftr].

FTR CODE:_ bksp save chg

4.2.1.Press the ! button.

4.2.2.Input the feature code 6/ (for CID Table review) and then press [save].

5.Continue programming other Flexible Feature Buttons or lift/replace the handset to exit this programming.

Headset Mode !9/

All Digital Speakerphones have a standard 2.5 millimeter headset jack. When Headset Mode is selected (either by pressing a preprogrammed

headset feature key or dialing the Headset Mode code), the button is used to activate/deactivate the headset.

When you press the button, Headset Mode active and the extension

status changes to an off-hook condition. When you press the button again, the extension status returns to idle, disconnecting any call in progress.

Operation – Activate Headset Mode

1.While the telephone is idle, press !9/ or press the Flexible Feature button designated as HEADSET MODE (if available). The display indicates the new status:

HEADSET ENABLED

Operation – Deactivate Headset Mode

1.While the telephone is idle, press !*9/ or press the Flexible Feature button programmed with the Headset Mode code. The display indicates the new status:

HEADSET DISABLED

Operation – Use the Headset to Place a Call

1.While the telephone is idle, press , a DSS button, or outside line

button. The button LED flashes to indicate that the headset is active. You hear Intercom dial tone, outside line dial tone, or Intercom ring-back tone, depending on the function invoked.

2.Press again to disconnect the current call.

Page 42 P7292 DETUG 09/01