Vidikron VP-5000VHDA, VP-103VHD, VP-6500VHDA operation manual Cable Management

Installation

To reduce cable clutter, use the cable clamps provided with the PlasmaView VHD to bundle	Cable Management
the video, audio and control cables at the back of the display. Install the clamps as shown in
Figure 3-14.

Securing the AC cord to the rear of the panel (VP-5000VHD)

1.Open the clamp.

Clamp

2. Insert the AC cord	3. Slide the clamp upward	4. Insert the end of the
and close the clamp	to secure the AC cord.	clamp band into the
securely.	To loosen	small hole on the lower
	the clamp:	right of
		the back
		cover.
AC cord

Note: The power plug provided with your panel may differ from the one shown here.

Securing the AC cord to the rear of the panel (VP-6500VHD)

		1	Connect the AC cord plug to
			the panel.
3	1	2	Attach the left clamp.
		3	Attach the right clamp.

2

Note: The power plug provided with your panel may differ from the one shown here.

To close:

Push until the hook clicks.

To open:

Squeeze the tabs together and pull out.

Securing the AC cord to the rear of the panel (VP-103VHD)

To close:

Unplug the AC cord

Plug the AC cord into the power inlet on the panel until it clicks.

Attach the clamp.

Note: Make sure that the AC cord is locked.

Push until the hook clicks.

To open:

Squeeze the tabs together and pull out.

Press the two tabs together and pull out.

Using Cable Ties

Pass the cable fixing band through the clip as shown.

1

To secure cables connected to the panel, wrap the cable tie around them.

Then, pass the pointed end through the locking block as shown. Ensure that there is sufficient slack in the cables to minimize stress, especially in the power cord.

To tighten:	To loosen:
	Push the catch
Pull
2	Pull

Figure 3-14. Cable Management

Vidikron PlasmaView VHD Installation/Operation Manual 31