Viking 15" W Drain Plumbing, Gravity Drain Gravity Drain Location, Drain Pump

DRAIN PLUMBING

Your ice machine uses a gravity drain that requires 5/8” (.63 cm) ID tubing from the back of the ice maker to a plumbed connection to a sanitary sewer (see Gravity Drain drawing below). Remove the access panel, with a 5/16” (0.8 cm) wrench to plumb in drain connection. Gravity drain location for built-in units can be within the area shown in illustration below. An optional drain pump can be purchased for your ice machine if a gravity drain is not accessible. Observe and follow all local codes when installing an ice machine.

WARNING

Failure to use adequate drainage system will result in surrounding water damage and/or poor ice production.

GRAVITY DRAIN						GRAVITY DRAIN LOCATION
					24 5/8” (62.6 cm)
					22” (55.9 cm)
								6 3/4”
				Top of							14 3/4”
							(17.1 cm)
											(37.5 cm)
		Front	of	Unit
		Unit								2 3/8” (6.0 cm)
								4	1/16”
								(10.3 cm)
	5/8" (.63 cm) I.D.
	DRAINTUBING
	AND HOSE CLAMP

1 1/2" (3.8 cm) DRAIN

PIPE

ACCESS PANEL

DRAIN TRAP

DRAIN FROM	ICE MAKER
ICE MAKER
	POWER CORD

DRAIN PUMP

Model Number - VUIM-DP

(Sold separately - see installation instructions supplied with drain pump)

TUBINGCLAMPS

VENT TUBE

SUPPLIED SCREWS

DRAIN FROM

ICE MAKER

DRAINPUMP

DRAINPUMP

POWER CORD

VENT TUBE GOES THRU THIS OPENING V NT TUBE GOES THRU THIS

OPENING}{ ININTHETHEACCESSACCESSPANELPANEL

DISCHARGE TUBE GOES THRU

THIS OPENING IN THE ACCESS PANEL

ACCESS PANEL

DRAININ PUMP'S}{PUMP’S DISCHARGEE

LINE THRU}{THISOPENING

11