ATTACHING THE OVERLAY PANEL TO THE DOOR
1.If the door is attached to the unit, remove by unscrewing the top allen head set screw at the top hinge. Remove the door by angling the door off of the bottom hinge pin.
2.Peel back the door gasket to expose the screw holes.
3.Set the overlay panel flush to the front of the door in the desired location. Clamp the overlay panel to the door if necessary.
4.Insert the wood screws through the back of the door into the pilot holes in the overlay panel and tighten.
5.Reinstall the door gasket by pressing into the door channel. Make certain the corners are inserted fully.
6.Install the door to the unit. Use the supplied plastic washer as shown in the figure below.
7.Realigning the door may be necessary. Any final door adjustments can be made using a 1/8” allen head driver to adjust the door’s brackets. (See figure below)
8.Attach the door to the unit by reversing step number 1 above.
Hinge Hardware Installation
Details
CAUTION |
| (2) NYLON |
DOOR CAN BECOME |
| |
| HARDWARE | |
DISENGAGED IF |
| |
| COMPONENTS | |
WASHERS ARE |
| |
NOT INSTALLED |
| AT TOP HINGE |
|
|
|
|
|
|
.625 OD X .218 ID |
WASHER |
SHOULDERBUSHING
DOOR HINGE
BUSHING BRACKET
OVERLAY PANEL
TOP HINGE CORNER
MAGNETIC
DOOR GASKET
0Ø0.383/8” CLEARANCEHOLES FOR SCREWS
8 HOLES
8
CAUTION
DOOR CAN BECOME DISENGAGED IF WASHERS ARE NOT INSTALLED
REFRIGERATOR DOOR
OVERLAY PANEL
DOOR HINGE
BUSHING BRACKET
SHOULDERBUSHING
REAR OF DOOR
.75 OD X .443 ID
WASHER |
.75 OD X .257 ID
CAUTION |
| WASHER | |
DOOR MAY NOT SWING |
|
|
|
PROPERLY IF ALL NYLON |
|
| (3) NYLON |
|
| HARDWARE | |
COMPONENTS ARE NOT |
|
| |
|
| COMPONENTS | |
INSTALLED AS SHOWN |
|
| |
|
| AT BOTTOM | |
|
|
| HINGE |
| BOTTOM HINGE CORNER | ||
|
| ||
|
| ||
ALLEN HEAD SCREWS |
1/8”INCH ALLEN HEAD SCREWS |
FOR HINGE ADJUSTMENT
DOOR HINGE
ADJUSTMENT SCREWS
ATTACHED OVERLAY PANEL | BOTTOM OF DOOR |
|
7
