Viking 15 W specs

LEG LEVELER INSTALLATION

READ BEFORE INSTALLING LEG LEVELERS

WARNING

Do not lay unit on top, side, back, or front. If unit is accidentally laid in any position other than right side up, then the unit must remain in the right side up position for at least 24 hours before plugging the unit in.

1.Tip unit backwards so there is (1) foot of clearance on front of the unit. Have someone to assist you in tilting the unit, to prevent it from falling on you while installing the leg levelers.

2.Screw front two leg levelers into the screw impressions. Leg levelers should be screwed in until snug.

3.Repeat steps 1 & 2, with the exception of tipping the unit forwards now, to screw in the back two leg levelers.

4.Your leg levelers are now installed.

5.The unit should be level from front to back and side to side. If floor conditions do not allow the unit to sit level, adjust leg leveler(s) by turning the required leg leveler(s) counter-clockwise to increase their height and clockwise to reduce their height.

Screw

Impressions

8

Image 8

Viking 15 W installation instructions LEG Leveler Installation Read Before Installing LEG Levelers

Contents

Proper Disposal of Your OLD Refrigeration Product For Your SafetyImportant Please Read and Follow General Information Undercounter Cabinet CutoutUnpack Area Requirements SPECIFICATIONS/DIMENSIONS Front ViewProfessional Models Vuim Side View SPECIFICATIONS/DIMENSIONS Designer Model DuimDfim 37 9/16 95.4 cm 22 55.9 cm 24 5/8 62.6 cm 25 5/8 65.1 cm Full Overlay Panel Installation Bottom View of Door with Left Hand Swing Selecting and Preparing the Overlay Panel Dfim Models 14 3/4 37.5 cm 15/16 22.7 cm TYP 13/16 14.8 cm Hinge Hardware Installation Details Attaching the Overlay Panel to the Door LEG Leveler Installation Read Before Installing LEG Levelers Wiring Diagram Undercounter 15 W. ICE Machine Electrical Connection Water Connection Water Supply Drain Plumbing Gravity Drain Gravity Drain LocationDrain Pump Model Number VUIM-DP HOW the ICE Machine Works ICE Machine FeaturesIce Machine Safety and Operation Tips Outdoor Use Using Your ICE MachineCleaning and Maintenance Cleaning the ICE Machine System Troubleshooting Guide Preparing the ICE Machine for Storage Ice machine selector switch is Selector switch is in the OFFOr Clean position Room and/or water temperature Room temperature is too warm Ice cubes are too small Low ice consumptionLess than 1/2 thick Not enough water in reservoir Grid cutter is not cutting Selector switch is not Room temperature is too coldAdjusting Low ice production. Unit Low water level in reservoir Service Information Final Preparation UNDERCOUNTER/FREESTANDING ICE Machine Warranty Units certified for Indoor Use Units certified for Outdoor Use