Viking InterWorks MAC OS Hardware Installation (Continued)

VIKING COMPONENTS 56K USB MODEM USER’S GUIDE

Hardware Installation (Continued)

2.Return the modem right side up and feed the phone cables through the back

of the base.

3.Power on your computer.

4. Locate an available USB port on your computer and connect it with the USB

cable on the back of the modem. This port is usually located on the back of your

system. If you are not familiar with the location of the USB ports on your com-

puter,please refer to your system’s “Owner’s Guide”for detailed instructions.

Note:The Viking Components USB modem must be connected to a USB port on

your computer or to a powered USBhub.

Your hardware setup in now complete. To complete the setup of your modem,

please proceed to the chapter 4 “Software Installation”in this guide.

Chapter 3

5

Contents

Main Table of Contents 1 Introduction Viking 56K USB Modem Features & Specifications 2 Before You Install System Requirements Phone Line Requirements Communications Software requirements 3 Hardware Installation Hardware Installation (Continued) 4 Software Installation Mac OS 8.5 or Later Driver Software Mac OS 8.5 or Later Driver Software (Continued) MacComCenter Communication Software Page Remote Access/Mac PPP Setup Free PPP Setup Using Data and Fax Communication Software Page 6 Troubleshooting Universal Serial Bus (USB) Basics General Troubleshooting 14 Problem Solution General (Continued) 15 Problem Solution 7 Basic AT Commands Guidelines Basic AT Command Set Page Page Page Page Page ECC Commands MNP 10 Commands MNP 10 Commands (Continued) Caller ID Commands Fax Class 1 Fax Class 2 Fax Class 2 (Continued) 8 Modem Driver & Firmware Upgrades 9 Contacting Technical Support Viking Components Technical Support Phone Number:888-801-9181 10 Communication Regulations INDUSTRY CANADA (IC) NOTICE PART 68 REQUIREMENTS PART 68 REQUIREMENTS (Continued) 11 Warranty & Disclaimers 5 YEAR WARRANTY