Viper 5901 manual Additional remote start features, Manual Transmission

Additional remote start features

Manual Transmission

If the vehicle has a manual transmission the proper steps must be fol- lowed before leaving the parked vehicle or the remote start feature is disabled.

1.Make sure the engine is running and the doors on the vehicle are closed.

2.Put the transmission in neutral.

3.Press on the brake in the vehicle.

4.Apply the emergency brake.

5.Release the brake.

Note: Pressing the brake pedal again after this step will disable the remote start feature.

6.Within 15 seconds activate the remote start from the remote.

7.The parking lights flash 5-times confirming that the remote start is active. If the parking lights do not flash 5-times, then repeat steps 1 - 6.

8.Turn off the ignition (the car stays running when key is turned off).

9.Exit the vehicle.

10.Arm the alarm (the vehicle should shut off when arming the sys- tem).

You can now remote start the vehicle. If a door is opened or the alarm is triggered before the next remote start activation the system will not remote start.

Note: To enable Valet take-over with a manual transmission, open the door and enter into manual transmission mode, as described above. The parking lights flash one-time when entering Valet take-over. Once you exit the vehicle you can lock the system and the car will remain

28 © 2008 Directed Electronics. All rights reserved.