Viper 5901 manual Timer mode, Command Press two-times and then

running. If the vehicle shuts down when locking, then the unit did not enter valet take-over mode.

Timer mode

Command: Press two-times and then .

Feedback: Small timer icon appears and text reads “timer start on”. The vehicle will confirm with 4 fast parking light flash- es.

Notes: Enables or disables the remote start timer mode.

The system must be armed for the timer mode to operate. The system will start every 3 hours for a maximum of six cycles until canceled by the brake, hood, or neutral safety shut-down wires. The remote will respond with the Start and Stop remote start notification during each Start and Stop of the Vehicle while in Timer mode.

Important: Use Timer Mode in open areas only. Never start and run the vehicle in an enclosed space such as a garage or carport.

To activate timer mode with a manual transmission:

1.Enter the MTS mode.

2.Exit the vehicle and arm the alarm.

3.Enter the timer mode. The parking lights quickly flash 4 times to confirm entry into timer mode (vehicle does not remote start at this point). Vehicle begins the timer mode sequence.

To exit timer mode with transmitter:

•Press twice and then press . Parking lights flash slowly four times confirming timer mode is exited.

To exit timer mode without transmitter:

1.Make sure the remote start system is not operating the engine.

© 2008 Directed Electronics. All rights reserved. 29