VIVOTEK - A Leading Provider of Multimedia Communication Solutions
Installation
Network deployment
Setup the Network Camera over the Internet
This section explains how to configure the Network Camera to Internet connection.
1.If you have external devices such as sensors and alarms, make connection from general I/O terminal block.
2.Connect the camera to a switch via Ethernet cable. Use Catagory 5 Cross Cable when Network Camera is directly connected to PC.
3.Connect the supplied power cable from the Network Camera to a power outlet.
| 1 |
3 | 1: Power |
2: Digital output |
3: Digital input
4: Ground
2
There are several ways to setup the Network Camera over the Internet. The first way is to setup the Network Camera behind a router. The second way is to utilize a static IP. The third way is to use PPPoE.
Internet connection via a router
Before setting up the Network Camera over the Internet, make sure you have a router and follow the steps below.
1.Connect your Network Camera behind a router, the Internet environment is illustrated as below. About how to get your IP address, please refer to Software installation on page 9 for details.
Internet
WAN (Wide Area Network ) | IP address : 192.168.0.3 | |
Subnet mask : 255.255.255.0 | ||
Router IP address : from ISP | ||
Default router : 192.168.0.1 | ||
| ||
LAN (Local Area Network) |
| |
Router IP address : 192.168.0.1 |
|
Cable or DSL Modem
IP address : 192.168.0.2
Subnet mask : 255.255.255.0
Default router : 192.168.0.1
User's Manual - 7
