Vivotek IP7142 manual Preset Position, Custom Command

VIVOTEK - A Leading Provider of Multimedia Communication Solutions

Preset Position

Click Preset Position to open the Preset Position page. In this page, you can set the preset position for the Network Camera. A total of 20 preset positions can be configured.

Follow the steps below to set preset positions:

1.Adjust the Network Camera to a desired position with the buttons on the right side of the window.

2.In the Preset position name text box, enter a descriptive name for the preset position. The preset position name allows up to forty characters. Click Add to take effect. The preset position name will appear in the Preset Positions drop-down list. To remove a preset position from the list, select a preset position name from the Preset Positions drop-down list and then click Delete.

3.You can click “Go to” to aim at preset positions, which will also displayed in the main page.

4.Click Save to take effect.

Custom Command

If the Custom camera (scanner) is selected as the PTZ driver, the PTZ control panel on the main page will not take effect. You need to configure command buttons to control the

PTZ scanner. Click Custom Command to open the Custom Command page. A total of five command buttons can be configured. Please refer to the user's manual of your PTZ scanner to enter the command in the following blanks.

Click Save to enable the settings and click Close to quit the page.

48 - User's Manual