Vivotek PZ7132 manual Network Deployment, Setup the Network Camera over the Internet

VIVOTEK

Network Deployment

Setup the Network Camera over the Internet

This section explains how to configure the Network Camera over an Internet connection.

1.If you have external devices such as sensors and alarms, connect them to the general I/O terminal block.

2.Connect the camera to a switch via Ethernet cable.

3.Connect the supplied power cable from the Network Camera to a power outlet.

3

1: Power

2: Digital ouput

3: Digital input

4: Ground

1

2

Ethernet Switch

There are several ways to set up the Network Camera over the Internet. The first way is to set up the Network Camera behind a router. The second way is to utilize a static IP. The third way is to use PPPoE.

Internet connection via a router

Before setting up the Network Camera over the Internet, make sure you have a router and follow the steps below.

1.Connect your Network Camera behind a router, the Internet environment is illustrated below. Regarding how to obtain your IP address, please refer to Software installation on page 12 for details.

Internet

WAN (Wide Area Network )	IP address : 192.168.0.3
	Subnet mask : 255.255.255.0
Router IP address : from ISP
	Default router : 192.168.0.1
LAN (Local Area Network)
Router IP address : 192.168.0.1

Cable or DSL Modem

IP address : 192.168.0.2

Subnet mask : 255.255.255.0

Default router : 192.168.0.1

8 - User's Manual