Getting Started
How to Use Humidifier Controls
Filling Water Tank
Before initial use, you must soak the Mineral Cartridge in water for 24 hours. You may use a separate container or Water Tank to do so. If Tank is used, empty water and refill with fresh water prior to use.
Note: the unit may take several minutes to create mist with the initial use of a new Mineral Cartridge.
A
AC
BD
This Humidifier has a 2 gallon capacity and 3.5 gallon output in 24 hours (if set to High output, Continuous Humidity setting).
To fill Water Tank:
1.Unplug Humidifier. Place on firm and level surface, such as the floor.
Note: Spills can occur during cleaning, moving, or refilling Water Tank, so be careful to avoid spills when doing these activities. Do not touch the water inside the Base, as the water temperature can reach 92 degrees F.
2.Remove Water Tank by grasping recessed handle on back (A). Lift and pull outward.
3.Turn Water Tank upside down.
4.Remove Cap (B). Empty any remaining water inside Water Tank. Rinse, wipe clean and dry with clean cloth or paper towel.
5.Place Water Tank in sink with opening at the top.
6.Fill Water Tank with cool tap water (C).
7.Ensure Gasket is properly positioned and secure Cap.
8.Lower Water Tank into Base, positioning Fill Port over raised bump in Base. Once in nested position, the water outlet valve inside Cap will open, releasing water into Base.
8English
BC
Note: The rate of water dispensing from Water Tank into Base is controlled by the Mineral Cartridge. The unit may take several minutes to fill the Base.
Read and understand this owners guide before operating this product. Position unit to not blow directly on objects or plants. Plug unit into a
Power Button (A) - turns the unit On or Off. LCD Screen will illuminate when powered On. Unit will default to Continuous Misting, Cool Mist, and High Output. Adjust settings for desired operation.
Mist Condition (B) - select Cool or Warm Mist Output. The temperature of the mist on the Warm Mist setting is approximately 94
Humidity (C) - sets desired humidity level. Press Humidity Button until desired humidification level is illuminated. The unit will operate until the desired humidity level is reached, at this point, the mist output will turn Off. The humidity level indicator light will remain on. If the mist output does not turn on, the set humidity level may be lower than the room humidity level. Increase the humidity set point until the mist turns on. This is an indication of the level of humidity already
in the room. If moisture forms on walls or windows, lower humidity settings or turn Off Humidifier.
AUTO 1 Continuous misting, cool mist, low fan speed. AUTO 2 Continuous misting, warm mist, high fan speed
40% - 60% Humidity level. Manually set Mist Condition and Fan Speed.
Fan Speed (D) - select desired Fan Speed - High or Low .
High - operation for fast humidification for larger rooms. High speed operation will evaporate 3.5 gallons of water (+/- 10%) in 24 hours of continuous operation. (This assumes room conditions of 70º F and 30% relative humidity.)
Low - operation for quiet, nighttime use or smaller rooms. On Low operation, your Humidifier may run without refilling for extended periods.
Notifications
Refill Tank - Notifies you when the Water Tank needs to be refilled. Will automatically turn off after it has been refilled.
Clean Unit - Displays after 400 hours of operation. It is recommended to clean your Humidifier at this time (see CLEANING INSTRUCTIONS). To reset notification, press and hold the Power Button for 3 seconds. Replace the Mineral Cartridge - Displays after 800 hours of operation. It is recommended to replace the Mineral Cartridge at this time
(see REPLACING MINERAL CARTRIDGE for instructions). To reset notification, press and hold the Power Button for 3 seconds.
English 9
