Getting Started
Setup
Installation of Battery Pack in Handset
Follow the steps below:
1.Remove the battery cover by pressing
on the indent and sliding downward.
2.Align the two holes in plug with the
socket pins. Insert the plug into socket. Place the battery pack into the compartment with the wires in one of the bottom corners of the battery pack.
3. Replace the battery cover by sliding it upwards.
4.If the new battery pack is not already charged, place the Handset in the
Base unit, or a remote charging stand, and allow it to charge for 12 hours. After initial charge, a maintenance charge of 8 hours should be sufficient.
The original Handset that is shipped with your v 2656 system will be automatically registered to the Base. This Handset is HANDSET 1.
As you register additional Handsets to the system, they will be assigned extension numbers in the following order: HANDSET 2, HANDSET 3, and finally HANDSET 4.
After a Handset battery pack is installed, the Handset will automatically begin SEARCHING FOR BASE (if previously registered), or it will prompt you to ENTER BASE ID to register the new Handset.
8
8 | 8/5/2004, 4:51 PM |
