Enter Base ID Code, Found Base | VTech v 2656 specification

Getting Started

Registration of Additional Handsets

Enter Base ID Code

1. After charging the Handset, if

the screen displays

SEARCHING FOR BASE, press NEW. You will see ENTER BASE ID. If the screen already says ENTER BASE ID, go to step 2.

2. Enter the 15 digit Base Unit ID

code, located on the underside of the Base Unit.

3. Press OK. The Handset will

display: PLEASE WAIT!! Then put the Handset onto the cradle.

4. Wait approximately 15 seconds.

The Handset will display:

FOUND BASE

If the Handset displays: BASE BUSY TRY LATER, this indicates that the system is in use. Wait until the Base Unit is in the idle (on hook) mode, and repeat steps 2 to 4.

NOTE: Occasionally, it may take longer than 15 seconds for the Handset to confirm registration to the Base Unit. This is normal.

Congratulations! You can now enjoy the benefits of your multi-Handset system.

12

91-005358-050-000 v2656.pmd

12

8/5/2004, 4:51 PM

Image 12

VTech v 2656 important safety instructions Enter Base ID Code, Found Base

Contents

Important Safety Instructions Vtech Communications INC Stop Introduction Parts Check List Handset Layout Base Unit Layout Setup Connecting Power to Base Unit Installation of Battery Pack in Handset Charging Of Handset Battery Pack Connecting to phone lineChecking for dial tone Case of Difficulty Wall Mounting Registration and Operation of the v 2600 Accessory Handset Setup of the v 2600 Accessory HandsetRegistration of Additional Handsets Enter Base ID Code Found Base Handset and Base Indicators Handset IconsBase Leds Icon Description Soft Menu Functions RDL RedialCaller ID Call Waiting ID Calls Log Caller ID See To Edit a Number/Name, on Handset Settings LOW Batt Tone preset to onRange Tone preset to on Keypad Tone preset to on Tone/Pulse Selection preset to Tone Range Extender preset to AutoRange EXTENDER, then press OK Range Extender menu Register and Memory Memory To Store a Number/Name Save To Search For and Dial a Number Name To Delete a Number/NameSearch For and Dial a Number To Edit a Number/Name Handset and Base Operation Making CallsAnswering Calls Mute Function Volume Control Flash FunctionFrom Base to ALL Handsets Switching between the Handset Earpiece and Speakerphone Handsfree Speakerphone OperationUse Indication Low Battery Indication Conference CallingTransferring Calls Audible Indicators Answering System OperationAnswering System Operation Turn Answering System On or Off About Mailboxes About AnnouncementsRecord Your Announcement AnsweringSystemOperation Answering System Feature Setup To review your announcementTo delete your announcement Default setting indicated by Set Security CodeSet Audible Message Alert Off Listen to Messages Adjust Playback Volume Press Volume or VolumeDelete Messages Delete a Specific Message Delete All Old Messages in a Mailbox Record a Memo Call Screening Counting 1 to 99, flashingSteady for one second 40-99 Remote Access Voice Menu Headset Operation Belt Clip Maintenance Handset Does Not Ring When You Receive a Call Case Of DifficultyPhone Doesnt Work At All No Dial Tone You Hear Other Calls While Using Your Phone Common Cure For Electronic EquipmentYour Answering System is not recording messages CL is flashing on the Base Unit Warranty Statement What does this limited warranty cover?How long is the limited warranty period? What is not covered by this limited warranty? How do you get warranty service? Other Limitations FCC, Acta and IC Regulations VTech Communications IncFCC Part FCC and Acta Information Repair instructionsRights of the telephone company Programming/testing of emergency numbers Hearing aid compatibilityIC Industry Canada Rbrc R Seal Technical Specifications Nominal Effective Range Table Of Contents Important Safety Instructions Getting StartedBasic Operation Advanced Operation Issue