Spare Battery Charger, Installation | VTech VT 1920C instruction

REPLACING THE BATTERY PACK

4.Exercise care in handling batteries in order not to short the battery with conducting materials such as rings, bracelets, and keys. The battery or conductor may overheat and cause burns.

To purchase replacement battery packs, call VTECH Communications at 1-800-595-9511. In Canada, call VTECH Electronics at 1-800-267- 7377.

SPARE BATTERY CHARGER

POWER VT 1920c

HS IN-USE

CHARGING

SPARE BATT

PAGE

CORDLESSDIGITAL900MHz

The VT 1920c has a built-in spare Battery Charger, which is located in the cradle of the Base Unit.

NOTE: In order to benefit from this feature, you must obtain an optional Spare Battery from an authorized VTech dealer, or by contacting VTech Customer Service at 1-800-595-9511 in the U.S.A and 1-800-267-7377 in canada.

Installation

Remove the Spare Battery charger cover by pressing the release tab and lifting up.

Place a battery pack in the Spare Battery charger. Make sure the metal charging contacts on the underside of the battery pack are aligned with the charging contacts in the Spare Battery charger.

POWER

VT 1920c

HS IN-USE

CHARGING

SPARE BATT

PAGE

CORDLESSDIGITAL 900MHz

11

1920manual

11

1/28/99, 3:27 PM

Image 11

VTech VT 1920C manual Spare Battery Charger, Installation

Contents

Introduction Special Features VT 1920c Parts Check List FCC Part FCC and IC Regulations FCC and IC Regulations FCC and IC Regulations E a d a n d u n d e r s t a n d a l l instructions Important Safety Instructions Important Safety Instructions Word about Rechargeable Batteries Ctions Replacing the Battery PackTo Charge The Battery Pack Charging the Handset BAT- Tery Pack Replace the battery case cover by sliding the cover upwards Installation Spare Battery Charger Replacing a Drained Handset bat- tery Power Backup Handset Ringer Getting Started Fill in the telephone number card on the base unit I N G T H E WA L L M O U N T Adaptor Wall Mounting LCD Display Messages LCD Display Handset Layout Handset Features Base Unit Layout Base Unit Features Quick Reference Guide Hold Using RedialMemory Dialing Speed Dialing CID Caller ID Basic Operation CID-CALLER ID Advanced FunctionsCall Waiting CLR/DEL Key Function Changing Ringer TypesChecking The Ringer Type Turning Off The Ringer Advanced Dialing Storing Memory Speed Dial numbers Memory Dialing Deleted Dialing From MemoryChanging Stored Numbers Deleting Stored Numbers Storing Special Codes Dialing from CID Memory CID-CALLER IDCall Waiting Caller ID Type II CID Receiving and Storing Calls Private Special Message Indicators Out of Area CallsTransmission Error Private Calls Reviewing Numbers Reviewing Numbers Deleting Numbers Noise or Interference OUT of Range When Phone is onOUT of Range When Phone is OFF Additional Operating Tips Taking Care of Your TEL- Ephone Maintenance Phone DOESN’T Work AT ALL Handset does not Ring When YOU Receive a CallYOU Hear Other Calls While Using Your Phone Case of Difficulty Common Cure for Electronic Equipment Warranty Statement What does OUR Warranty not COVER? Technical Specifications Table of Contents Issue