Technical Specifications | VTech VT 1920C specs

TECHNICAL SPECIFICATIONS

FREQUENCY CONTROL

Crystal Controlled Dual PLL Synthesizer

TRANSMIT FREQUENCY

Handset : 925.05 MHz to 927.75 MHz ( All ten channels within this range)

Base : 902.3 MHz to 905.0 MHz (All ten channels within this range)

RECEIVE FREQUENCY

Handset : 902.3 MHz to 905.0 MHz ( All ten channels within this range)

Base : 925.05 MHz to 927.75MHz ( All ten channels within this range)

WEIGHT

Handset : 250 grams

Base : 415 grams

POWER REQUIREMENTS

Handset : Self-contained nickel- cadmium rechargeable battery supply, 3 . 6V nominal, 600mAh capacity.

Base: 9VDC @ 300mA

MEMORY

Speed Dial:20 Memory locations, 20 digits per location.

CID	: Alpha Numeric Display 50
	Memory locations

NOMINAL EFFECTIVE RANGE Maximum power allowed by FCC and IC. Actual operating range may vary according to environmental conditions at the time of use.

SIZE

Handset : 19 x 6 x 3.5cm (L x W xT) Maximum (Antenna ex- cluded)

SPECIFICATIONS ARE TYPICAL AND MAY CHANGE WITHOUT NOTICE.

Base : 21.5 x 14.5 x 5cm (L x W x T) Maximum (Antenna excluded)

38

1920manual

38

1/28/99, 3:28 PM

Image 38

VTech VT 1920C manual Technical Specifications

Contents

Introduction Special Features Parts Check List VT 1920c FCC and IC Regulations FCC Part FCC and IC Regulations FCC and IC Regulations Important Safety Instructions E a d a n d u n d e r s t a n d a l l instructions Important Safety Instructions Charging the Handset BAT- Tery Pack Ctions Replacing the Battery PackTo Charge The Battery Pack Word about Rechargeable Batteries Replace the battery case cover by sliding the cover upwards Spare Battery Charger Installation Power Backup Replacing a Drained Handset bat- tery Getting Started Handset Ringer Fill in the telephone number card on the base unit Wall Mounting I N G T H E WA L L M O U N T Adaptor LCD Display LCD Display Messages Handset Features Handset Layout Base Unit Features Base Unit Layout Quick Reference Guide CID Caller ID Using RedialMemory Dialing Speed Dialing Hold Basic Operation CID-CALLER ID Advanced FunctionsCall Waiting Turning Off The Ringer Changing Ringer TypesChecking The Ringer Type CLR/DEL Key Function Advanced Dialing Memory Dialing Storing Memory Speed Dial numbers Deleting Stored Numbers Dialing From MemoryChanging Stored Numbers Deleted Storing Special Codes Receiving and Storing Calls CID-CALLER IDCall Waiting Caller ID Type II CID Dialing from CID Memory Private Calls Special Message Indicators Out of Area CallsTransmission Error Private Reviewing Numbers Reviewing Numbers Deleting Numbers Additional Operating Tips OUT of Range When Phone is onOUT of Range When Phone is OFF Noise or Interference Maintenance Taking Care of Your TEL- Ephone Case of Difficulty Handset does not Ring When YOU Receive a CallYOU Hear Other Calls While Using Your Phone Phone DOESN’T Work AT ALL Common Cure for Electronic Equipment Warranty Statement What does OUR Warranty not COVER? Technical Specifications Table of Contents Issue