Getting Started, Handset Ringer | VTech VT 1920C specs

GETTING STARTED

Setting Up Your VTech VT 1920c Choose an area near an electrical outlet and a telephone wall jack.

AC Power Adaptor

Plug the AC power adaptor into an electrical outlet and the DC connector to the back of the base unit.

TELEPHONE

WALL JACK

AC

OUTLET

9V DCTEL LINE

CAUTION:

Use only CLASS 2 9V DC POWER SUPPLY included with your phone.

Handset Ringer

The handset ringer is programmed ON as the factory default setting. Refer to PROGRAMMING THE RINGER on page 21 for more information.

PULSE

	TONE PULSE
TONE	SELECTION
TONE

Charge the handset battery pack before use. The battery pack recharges automatically whenever the handset is in the base unit. The batteries must be charged for 16 hours before using your phone for the first time.

POWER

HS IN-USE

CHARGING

SPARE BATT

CHARGE THE

HANDSET

BATTERY PACK

FOR 16 HOURSDIGIT

CORDL

BEFORE USING

Setting the Tone/Pulse Switch The TONE/PULSE switch is located on the bottom of the base unit and is factory set to TONE. If you have touch tone service, do not change the switch setting. If you have rotary (Pulse) service, set the switch to PULSE.

Connect Telephone Line Cord Plug one end of the telephone cord into a wall jack and the other end into the back of the Base Unit.

13

1920manual

13

1/28/99, 3:27 PM

Image 13

VTech VT 1920C manual Getting Started, Handset Ringer

Contents

Introduction Special Features VT 1920c Parts Check List FCC Part FCC and IC Regulations FCC and IC Regulations FCC and IC Regulations E a d a n d u n d e r s t a n d a l l instructions Important Safety Instructions Important Safety Instructions To Charge The Battery Pack Ctions Replacing the Battery PackCharging the Handset BAT- Tery Pack Word about Rechargeable Batteries Replace the battery case cover by sliding the cover upwards Installation Spare Battery Charger Replacing a Drained Handset bat- tery Power Backup Handset Ringer Getting Started Fill in the telephone number card on the base unit I N G T H E WA L L M O U N T Adaptor Wall Mounting LCD Display Messages LCD Display Handset Layout Handset Features Base Unit Layout Base Unit Features Quick Reference Guide Memory Dialing Speed Dialing Using RedialCID Caller ID Hold Basic Operation Call Waiting Advanced FunctionsCID-CALLER ID Checking The Ringer Type Changing Ringer TypesTurning Off The Ringer CLR/DEL Key Function Advanced Dialing Storing Memory Speed Dial numbers Memory Dialing Changing Stored Numbers Dialing From MemoryDeleting Stored Numbers Deleted Storing Special Codes Call Waiting Caller ID Type II CID CID-CALLER IDReceiving and Storing Calls Dialing from CID Memory Transmission Error Special Message Indicators Out of Area CallsPrivate Calls Private Reviewing Numbers Reviewing Numbers Deleting Numbers OUT of Range When Phone is OFF OUT of Range When Phone is onAdditional Operating Tips Noise or Interference Taking Care of Your TEL- Ephone Maintenance YOU Hear Other Calls While Using Your Phone Handset does not Ring When YOU Receive a CallCase of Difficulty Phone DOESN’T Work AT ALL Common Cure for Electronic Equipment Warranty Statement What does OUR Warranty not COVER? Technical Specifications Table of Contents Issue