VTech VT 1962 manual Wall Mounting, Using The Wall Mount Adapter

WALL MOUNTING

Using The Wall Mount Adapter

1.Choose a spot near an electrical outlet and a telephone jack.

You phone requires a modular telephone jack and a standard electrical outlet (120v AC). The power cord is six feet long; make sure there is an electrical outlet within reach of the Base Unit. The outlet should not be controlled by a wall switch. If the switch is ever turned off, the phone will not operate.

2.Position the wall mount bracket on the Base.

Line up the tabs on the wall mount adaptor with the holes on the bottom of the Base (Figure 1). Snap the wall mount bracket firmly in place.

3.Mount the Base on the wall.

Position the Base so the mounting studs will fit into the holes on the bottom of the Base. Position the power cord to extend down the wall the phone is to be mounted on. Slide the Base down on the mounting studs until it locks into place.

4.Connect the telephone line cord.

The telephone line cord has a snap-in plug at each end. Insert one of the plugs into the jack on the bottom of the Base. Insert the other end of the plug into the wall jack.

5.Plug the AC adaptor into an electrical outlet and the DC connector into the power jack located on the back of the Base Unit .

TONE

PULSE

Figure 1

DELETE

TIME/SET SELECTMENU

REPEAT/SLOW SKIP/QUICK VOLUME

PAGE

Figure 2

15