Changing Channels

OPERATING INSTRUCTIONS

3.Press the LINE key to return to the remaining call.

If you want to end the entire Confer- ence call, press OFF on the Handset (or Base) while both Lines are active.

CAUTION: If the Handset and Speakerphone are on the same call, a loud squeal due to feed- back may occur unless there is reasonable separation between the two components.

TONE 0OPER

HOLD CHAN INT.COM

PGM CONF REDIAL

MEM

PAUSE

If you notice interference when using your Handset, press CHAN to switch to a clear channel. This function is only available when you are on a call or us- ing Intercom.

Page 23

Image 23

Contents

Introduction Features Wall Mounting Bracket Base Unit Battery pack Handset Belt clip AC adapterParts Check List Read and understand all instruc- tions Important Safety Instructions Rbrctm Seal If the product exhibits a distinct Change in performance Replacing the Handset Battery To install the Spare Battery Pack Spare Battery Charger Charge the Handset BATTER- IES Before USE. The batteries Getting Started Never install telephone wiring dur- ing a lightning storm Wall Mounting Handset Features Charge LED Base Unit FeaturesPower LED Spare Batt LED TONE/PULSE Switch OFF KEY Volume UP KEYVolume Down KEY Ringer Switches Making Calls Operating Instructions To PUT a Call on Hold Mute FeatureTips on Usingthe VT 9241 Speak Erphone Answer a Call From the Base Unit Pressing the VOL UP or Down keysMaking or Answering a Call While YOU’RE Already on a Call Ference Calling Joining a Conversation Press Hold on the HandsetPress the appropriate Line key on the Base Unit Using the Intercom Programming the Ringer Type Using the Intercom During a Phone CallTemporary Tone Feature If Your Phone Rings During AN Intercom Conversation Checking the Ringer Turning OFF the RingersTo turn off the ringer on the Handset do the following Press PGM/MEM Storing a Pause in a Speed Dial Number To Store a Number Into MemoryTo Speed Dial a Stored Number To Change or Replace a Stored Number Conference Calling Using RedialStoring a Redial Number in Memory Speed Dial Ending One Side Or Entire Confer- ence Call Switching a Conference Call From Handset To Base UnitSwitching a Conference Call From Base Unit To Handset Way Conference Calling Changing Channels Installation Optional Headset Installation and Operating Instructions ONE Inch Data Port Electrical Storms MaintenanceExcess water or cleaning solvents of any kind Taking Care of Your TELE- Phone No Dial Tone Handset does not Ring When YOU Receive a CallCase of Difficulty Phone DOESN’T Work AT ALL Your Caller Fades in and OUT YOU Hear Other Calls While Using Your PhoneBase does not Ring Common Cure for Electronic Equipment Warranty Statement HOW does State LAW Relate to this WARRANTY? What does OUR Warranty not COVER? FCC Part FCC and IC RegulationsUnited States Canada Vtech Electronics This telephone is registered for use in Canada IC Industry Canada Office Receive Frequency Technical SpecificationsTransmit Frequency Weight Power Requirements Table of Contents If Your Phone Rings During AN Intercom Conversation 91-5073-10-00 Issue

VTech VT 9241 manual Changing Channels

Models: VT 9241

OPERATING INSTRUCTIONS

CHANGING CHANNELS