Vulcan-Hart 7066A1 ML-104496, 7888A1 ML-104493, 7019A1 ML-104497 ASSEMBLY Legs, Casters

ASSEMBLY

Legs

If oven is to be mounted on legs, assemble legs to the oven. Tip oven back and install two front legs with bolts through bottom of oven base frame. Tip oven forward, block up back and install rear legs.

Remove shipping harnesses from the burner area. If oven is to be placed on legs, do not remove burner shipping harness until legs have been assembled to the oven. To remove shipping harnesses, dismantle the oven deck and insulation pans. Remove 1 cotter pin and 2 wire straps from the burner area. Replace insulation pans and oven deck.

Casters

If casters are assembled to the oven, the installation must be made using a connector (not supplied by Vulcan) that complies with the Standard for Connectors for Movable Gas Appliances, ANSI-Z21.69 (latest edition), and a quick-disconnect device that complies with the Standard for Quick-Disconnect Devices for Use With Gas Fuel, ANSI-Z21.41 (latest edition). Provide a restraining device for the gas line to limit movement of the oven without depending on the connector and/or any quick-disconnect device or its associated piping to limit oven movement. Attach the restraint at the rear of the oven (Fig. 1).

CONNECT GAS LINE STRAIN RELIEF HERE

Fig. 1

PL-51216

If disconnection of the restraint is necessary, turn off the gas supply before disconnection. Reconnect this restraint prior to turning the gas supply on and returning the oven to its originally installed position.

Stacking Model 7016A1, 7018A1 and 7019A1 Ovens

The Vulcan 7000 Series Oven is offered in three different configurations:

•Bake Oven 7016A1 and 7018A1.

•Roasting Oven 7019A1.

•Baking and Roasting Oven 7096A1 or 7098A1 Combination Ovens.

— 8 —