Vulcan-Hart ML-52497, CB1824E operation manual Maintenance, Service and Parts Information

OFF, turn the conveyor speed to 5. Using a plastic abrasive pad, carefully wipe the conveyor belt in

ahorizontal motion (side-to-side) to remove baked-on product. Wipe the conveyor in the same manner with a hot damp cloth. When the open link of the conveyor is accessible at the front, turn the main power switch OFF. WARNING: DISCONNECT ELECTRIC POWER.

1.Lift up to remove the top cover and top reflector.

2.Slide the bottom deflector pan out the side.

3.Remove the rear deflector by lifting over the supports.

4.Relax the conveyor chain by pressing down on the top of the chain and disconnect at the open master link. When reconnecting the chain's master link, the weight of the chain holds it in place.

5.With the chain removed, the middle deflector pan and conveyor support rods can be removed.

6.Lift up to remove the exit tray; its support legs must be removed from the side pins.

7.Clean parts in a sink with warm soapy water, rinse, and wipe dry.

8.Reassemble all parts before returning oven to operation.

TOP	TOP
COVER
	REFLECTOR
		ADJUSTABLE
		EXIT
		TRAY
		REAR DEFLECTOR
		MIDDLE DEFLECTOR
CONVEYOR		PAN
CHAIN		BOTTOM DEFLECTOR
		PAN
	Fig. 2	PL-52403
MAINTENANCE

The drive motor bearings are permanently lubricated and do not require any lubrication maintenance.

The conveyor chain does not require any lubrication maintenance.

With reasonable care and periodic cleaning, the oven requires no customer applied maintenance.

SERVICE AND PARTS INFORMATION

WARNING: DISCONNECT ELECTRICAL POWER SUPPLY BEFORE SERVICING THE OVEN.

To obtain service and parts information concerning this oven, contact the Vulcan-Hart Service Agency in your area (refer to listing supplied with the oven), or Vulcan-Hart Company Service Department at the address or phone number shown on the front cover of this manual.

FORM 30995 (9-96) — 8 — PRINTED IN U.S.A.