Waves L3-LL user manual Band Controls, Separation, Crossover Xover Controls, Per Band Solo

L3-LL User Manual

Band Controls

The Band Controls section features controls over the Crossover network which splits the input into Frequency Bands. Each Band has controls for Solo, Gain, Priority, Release, and a Meter displaying the input level.

Separation

-Range 0 to 100

-Default 100

Separation is similar to a filter cutoff slope (or Q) between the bands’ sidechain being fed to the PLMixer™. At low Separation settings, crossover slopes between bands are moderate, creating more overlap between the bands. At higher Separation settings, the crossover slopes are steeper, resulting in less overlap between the bands.

Crossover (Xover) Controls

Just below the graph are the Crossover frequency adjustment controls. There are 4 Crossovers in the L3-LL. Each sets the cutoff frequencies for the corresponding High Pass and Low Pass filters.

Each of the four Crossovers has a unique range of frequencies, as follows:

LOW Range: 20Hz to 350Hz. Default to 80Hz.

LOW MID Range: 150Hz to 300Hz. Default to 320Hz.

HI MID Range: 1000Hz to 5000Hz. Default to 1278Hz.

HI Range: 3kHz to 11kHz. Default to 5113Hz.

Per Band Solo

Solo the frequency band to adjust the frequency bandwidth. Solo outputs the signal post the crossovers and pre the dynamic process.

15