Wayne-Dalton 6600 Optional Installation, Door Arm Hookup, Inside Lock, Pull Down Rope

Models: 6600

1 22
Download 22 pages 62.1 Kb
Page 18
Image 18
Optional Installation

Optional Installation

Door Arm Hookup

Align hole in the door arm with holes in operator bracket tabs, as shown. Attach with 5/16” x 1-3/4” cotter pin and cotter ring, as shown.

Drawbar operator

5/16” x 1-3/4”

Clevis pin

bracket tabs

Cotter

 

ring

Cotter ring

5/16” x 1-3/4”

Door arm

Clevis pin

 

Inside Lock

Install the inside lock on the second section of the door. Secure the lock to the section with

(4)1/4” - 20 x 11/16” self drilling screws. Square the lock assembly with the door section, and align with the square hole in the vertical track. The inside lock should be spaced ap- proximately 1/8” away from the section edge.

Important : Inside lock(s) must be removed or made inoperative in the unlocked position if an operator is installed on this door.

 

Square hole in

 

vertical track

Second section

 

 

(4) 1/4”-20 x 11/16”

 

Self drilling screws

Inside lock

1/8”

 

End stile

 

Pull Down Rope

Door Arm Hookup WarningARNING

Do not install pull down rope on doors with operators. Children may become entangled in the rope causing severe or fatal injury.

Measure and mark the jamb approximately 48” to 50” (1220 to 1270 mm) from floor on the right or left side of jamb. Drill 1/8” pilot hole for no. 6 screw eye. Tie the pull down rope to the no. 6 screw eye and to the bottom corner bracket, as shown.

 

No. 6 Screw eye

 

Typical bottom

 

corner bracket

48” to 50”

Pull down

From floor

rope

 

Pull

 

down

 

rope

 

Interior Lite Caulking

NOTE: After your door is installed, field caulking is required for lited sections in applica- tions subjected to heavy frost and or condensation forming on the inside of the windows.

Not caulking the inside of the lite frames in these applications can subject the door to high amounts of moisture on the interior and may damage the door. Use acrylic latex plus silicone caulk.

First, caulk the perimeter of the inside of the lite frames to the glass located in the top sec- tion. Next, caulk the lite frames to the top section surface at the horizontal top edge only.

IMPORTANT: Not caulking your door may void the warranty.

 

Caulk

Caulk

 

Caulk

Caulk

Top section

Typical lite frames shown

 

18

Page 18
Image 18
Wayne-Dalton 6600 Optional Installation, Door Arm Hookup, Inside Lock, Pull Down Rope, Interior Lite Caulking