18
Step 8Connect barbecue gas supply line to the naturalgas supply

Note - We recommend that the connection between

the barbecue gas supply line and the natural gas

supply be flare to flare. A 3/8-inch flare fitting has

been included with the barbecue gas supply line of

your gas barbecue.The fitting is loosely connected for

shipping and should be removed before installation.

You will need: barbecue gas supply line, 3/8 inch flare
fitting, 3/4 inch and 11/16 inch wrenches.
WARNING:This barbecue is NOTportable. It must
be bolted down at all times when it is connected to a
natural gas supply.
Unscrew the 3/8 inch flare fitting from the barbecue gas
supply line. Apply pipe sealant to the threads of the
pipe fitting. Screw the pipe fitting end of the 3/8 inch
flare fitting into the natural gas supply pipe. Tighten with
an 11/16 inch wrench. Figure 16 (a).
Attach the flare nut on the barbecue gas supply line to the
flare fitting end of the 3/8 inch flare fitting. Tighten with a
3/4 inch wrench. Figure 16 (a).
Attach the flare nut at the other end of the barbecue gas
supply line to the manifold fitting. Tighten with a 3/4 inch
wrench. Figure 16 (b).
Step 9Check all valves are off
You will need: one burner control knob.
(Valves are shipped in the OFFposition, but you should
check to be sure.) Put the knob on each valve. Check by
pushing down and turning clockwise. If they do not turn
they are off. Proceed to the next step. Figure 17.
Figure 16
(a)
(b)
Natural Gas
Supply Pipe
Pipe fitting end
of 3/8-inch
Flare Fitting
Flare fitting end of
3/8-inch Flare Fitting Barbecue gas
supply line
Apply pipe
sealant here
Figure 17
Step 10Install manifold bracket
You will need: manifold bracket.
Hook the bracket onto the manifold at the center burner
valve. Figure 18. Place your hand underneath the bracket.
Lift the bracket, manifold and cooking box slightly as a unit
and hook onto the frame brace. Figure 18 (a).
View from below
cooking box
Frame brace
Manifold bracket
Figure 18
(a)