Rotisserie Troubleshooting
Problem | Check | Cure |
Burner does not light. | Did you hold the burner control | Try to relight burner by holding |
| knob down and hold down for 20 | burner control knob down and |
| seconds until after burner ignited? | continue holding down until 20 |
|
| seconds after burner has ignited. |
|
|
|
| Did you wait to see the entire | When relighting burner by holding |
| ceramic surface become alight | burner control knob down, wait to |
| before counting 20 seconds? | see the entire ceramic surface |
|
| become alight before counting 20 |
|
| seconds? |
|
|
|
| Is the igniter sparking? | Replace battery in igniter button |
|
| module. |
|
| Reseat burner ring. |
|
|
|
Burner does not light or burner | The excess flow safety device, | Too reset the excess flow safety |
has a small flickering flame. | which is part of the grill to cylinder | device turn all burner control knobs |
| connection, may have activated. | and the cylinder valve OFF. |
|
| Disconnect the regulator from the |
|
| cylinder. Turn burner control knobs |
|
| to HIGH. Wait at least 1 minute. Turn |
|
| burner control knobs OFF. |
|
| Reconnect the regulator to the |
|
| cylinder. Turn cylinder valve on |
|
| slowly. Refer to “Lighting |
|
| Instructions” |
|
|
|
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your region using the contact information sheet provided with your manual.
