Weber 42372 manual Rotisserie Troubleshooting

26 ROTISSERIE TROUBLESHOOTING

PROBLEM	CHECK	CURE
Burner does not light.	Did you hold the burner control knob	Try to relight burner by holding burner control knob down and continue
	down and hold down for 20 seconds	holding down until 20 seconds after burner has ignited.
	until after burner ignited?
	Did you wait to see the entire ceramic	When relighting burner by holding burner control knob down, wait to see
	surface become alight before counting	the entire ceramic surface become alight before counting 20 seconds?
	20 seconds?
	Is the igniter sparking?	Replace battery in igniter button module. Reseat burner ring.
Burners do not light. -or- Burners	The excess fl ow safety device, which	To reset the excess fl ow safety device turn all burner control knobs
have a small flickering flame in	is part of the barbecue to cylinder	and the cylinder valve OFF. Disconnect the regulator from the cylinder.
the HIGH position. -or-	connection, may have activated.	Turn burner control knobs to HIGH. Wait at least 1 minute. Turn burner
Barbecue temperature only		control knobs OFF. Reconnect the regulator to the cylinder. Turn
reaches 250˚ to 300˚ in the HIGH		cylinder valve on slowly. Refer to “Lighting Instructions”.
position.

If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®.