Step 19
Install bottom accessory trays
You will need: two accessory trays
Set the two accessory trays between the two frame connectors. Figure 23.
Figure 23
Step 20
Install igniter
Note - The igniter wires are already attached to the Gas Catcher Ignition Chamber and the igniter. This was done to factory test the ignition system.
The igniter lock nut is on the igniter.
Insert the top of the igniter up through the large part of the keyhole in the frame brace. Loosen the igniter lock nut and slide the igniter into the small part of the keyhole. Tighten the igniter lock nut. Figure 24.
Note - If the igniter works loose, carefully tighten the igniter lock nut with an adjustable wrench or pliers.
(a)
(b)
Keyhole in frame brace
Igniter lock nut
Figure 24 | (c) |
Frame brace |
Frame brace | Small part of |
| |
| keyhole in |
| frame brace |
19
