Weber 5000 owner manual Install manifold bracket, Install brace panel, Install right end panel

Step 16

Install manifold bracket

You will need: manifold bracket

Hook the bracket onto the manifold at the center burner valve. Figure 19. Place your hand underneath the bracket. Lift the bracket, manifold and cooking box slightly as a unit and hook onto the frame brace.

Manifold bracket

Frame brace

Figure 19

Step 17

Install brace panel

You will need: brace panel.

Slide the side burner back. Insert the tabs into the slots in the frame brace at the wheel legs. (Make sure the side burner hose is to the front of the barbecue.) Figure 20 (a). Slide up until the notch at the bottom of the brace panel fits over the cross brace. Figure 20 (b).

Slot in frame brace

(a)

Frame brace

Step 18

Install right end panel

You will need: right end panel (Number 3), 1/4-20 x 1 1/2 inch bolt, 1/4-20 hex nut, two nylon washers, 1/4-20 x 1/2 inch bolt, 1/4-20 wing nut and a 7/16 inch wrench.

Set the right end panel over the brace panel. Make sure the gas supply hose is on the outside of the panel. Put the washer on the 1/4-20 x 1 1/2 inch bolt and insert bolt through both panels and frame brace. Add hex nut and tighten. Figure 21.

Side burner hose

Figure 21

Place a nylon washer on the 1/4-20 x 1/2 inch bolt. Insert the bolt through the top of the right end panel and the brace panel. Put on wing nut and tighten. Figure 22.

Tabs on brace panel

Side burner	(b)
hose

Figure 20

Figure 22

Cross brace

18