Step 18
Connect barbecue gas supply line to the natural gas supply
Note - We recommend that the connection between the barbecue gas supply line and the natural gas supply be flare to flare. A
You will need: barbecue gas supply line, 3/8 inch flare fitting, 3/4 inch and 11/16 inch wrenches.
WARNING: This barbecue is NOT portable. It must be bolted down at all times when it is connected to a natural gas supply.
Unscrew the 3/8 inch flare fitting from the barbecue gas supply line. Screw the pipe fitting end of the 3/8 inch flare fitting into the natural gas supply pipe. Tighten with an 11/16 inch wrench. Figure 22 (a).
Attach the flare nut on the barbecue gas supply line to the flare fitting end of the 3/8 inch flare fitting. Tighten with a 3/4 inch wrench. Figure 22 (a).
Attach the flare nut at the other end of the barbecue gas supply line to the manifold fitting. Finger tighten only. Hold the supply line against the upright frame crosspiece and tighten the fitting at the manifold using the 3/4 inch wrench. Figure 22 (b).
(b)
Step 19
Check that all burner valves are off
You will need: one burner control knob.
(Valves are shipped in the OFF position, but you should check to be sure.) Put the knob on each valve. Check by pushing down and turning clockwise. If they do not turn they are off, proceed to the next show. Figure 23.
Figure 23
Figure 22 | (a) |
Natural Gas
Supply Pipe
Pipe fitting end of
Flare fitting end of
24