Weber 5500 owner manual Step, Install glass doors, Complete accessory installation

Step 33

Install glass doors

You will need: one LH glass door assembly and two RH glass door assemblies.

Start with the LH door assembly. Insert the long hinge pin at the top of the door into the plastic bushing in the underside of the left frame. Insert the bottom (short) hinge pin into the bushing in the frame connector. Repeat the procedure with the RH door assemblies. The glass doors latch on the frame connector. Figure 49.

Bushing in underside and long hinge pin

Bushing in frame connector and short hinge pin

Figure 49

Step 34

Complete accessory installation

You will need: work table, serving tray, Warm-Up Basket, warming rack, thermometer, two tubing plugs and a hammer.

Insert one end of the Weber Warm-Up Basket into the hole in the right end of the lid and the other end into the slot in the left end of the lid. Figure 50 (a).

Set the work table onto the left side rails. Figure 50 (b).

Place porcelain serving tray on the work table. Figure 50 (c).

Set the warming rack into the slots at the rear of the cooking box. Figure 50 (d).

Insert the thermometer into its holder. Figure 50 (e).

Insert tubing plugs into the ends of the frame. To fully seat the plugs, you may have to tap them lightly with a hammer. Figure 50 (f).

(a)

(e)

(c) (d)

(b)

(f)

Figure 50

34