Weber 5500 owner manual Step, Install left hand swing table

Step 27

Install left hand swing table

You will need: swing table end bracket, two 10-24 hex nuts, two 10-24 x 1 3/4 inch machine screws, left hand slide bar assembly, swing table, four nylon washers, screwdriver and pliers.

Allow the slide bar to hang down. Push the support rod into the lower support bracket. Figure 35 (a). Swing the rod up so you can slide the rod all the way inside the locking tab. Figure 35 (b). The rod should swing freely inside the locking tab. Figure 35 (c).

(b)(c)

Support rod

(a)

Slide bar assembly

Figure 35

Insert one end of the hinge rod into the hole in the frame. Figure 36 (a).

Insert the other end into the hole in the swing table end bracket. Figure 36 (b). Hold the end bracket at an angle so the lower tab is inside the frame tube. Push the bracket into the frame. Check to see that the lower tab of the bracket is hooked in the slot in the frame. Figure 36 (c).

To fully seat the bracket, you may have to tap it lightly with a hammer.

WARNING: If swing table end bracket is in any way cracked or damaged, do not use swing table. Call our Customer Service Center to order a new part.

WARNING: The load limit for the swing table is 30 pounds.

Hinge rod

(a)

(b)

View from rear

of barbecue

(c)

Figure 36

Slot in frame (view from below)

29