Smoker Burner Ignition & Usage

SMOKER BURNER IGNITION

mDANGER

Failure to open the lid while igniting the grill, or not waiting five minutes to allow the gas to clear if the grill does not light, may result in an explosive flare-up which can cause serious bodily injury or death.

Smoker Burner Snap Ignition

Note: The control knob snap igniter creates a spark from the igniter electrode to the burner lighting tube.You generate the energy for the spark by pushing in the control knob and turning to START/HI.This will ignite the smoker burner.

mWARNING: Check hose before each use of grill for nicks, cracking, abrasions or cuts. If the hose is found to be damaged in any way, do not use the grill. Replace using only Weber® authorized replacement hose. Contact the Customer Service Representative in your area using the contact information on our web site.

Log onto www.weber.com®.

A)Open the grill lid (1)..

B)Open smoker box lid (2)..

C)Fill smoker with water soaked wood chunks or chips (3)..

D)Make sure that all burner control knobs not being used are turned to OFF (4).. (Push control knob in and turn clockwise to ensure that it is in the OFF position)..

E)Turn on the gas at source (5)..

mWARNING: Do not lean over the open grill while lighting.

F)Push the control knob in and turn to START/HI until you hear the igniter snap (6), continue to hold control knob in for two seconds.. This action will spark the igniter, the burner lighting tube, and then smoker burner..

G)Check that the burner is lit by looking through the cooking grates (7).. You should see a flame.. If burner does not light on first try, push control knob in and turn to OFF.. Repeat lighting procedure a second time..

mDANGER

If the smoker burner still does not light, turn the burner control knob to OFF and wait five minutes to let the gas clear before you try again, or try lighting with a match (see