Clean Burner Tubes
You will need: A flashlight, a wire (a
A)Look inside each burner tube with a flashlight (5).
B)Clean any debris or blockage from the inside of the burner tubes with the wire (6).
C)Check spider/insect screens at the ends of the burner tubes and clean them using the soft bristle brush (7).
mCAUTION: Do not clean the spider/ insect screens with hard or sharp tools. Do not dislodge the spider/ insect screens or enlarge the screen openings.
D)Use the steel bristle brush to clean the outside of the burner tubes. This is done to make sure all burner ports (openings) running along the length of the burner tubes are fully open (8).
mCAUTION: Do not enlarge the burner ports when cleaning.
Reinstall Burner Tubes
You will need: A 3/8" nut driver.
A)Carefully slide the inside burner tube back into hole in right side of cookbox (9), aligning burner tube opening with valve orifice (10).
B)Reinstall screw that holds the inside burner tube to the cookbox.
C)Repeat this procedure for the outside burner tube (11).
mCAUTION: The burner tube openings (12) must be positioned properly over the valve orifices (13).
mWARNING: You should check for gas leaks every time you disconnect and reconnect a gas fitting. Refer to
“CHECKING FOR GAS LEAKS.”
D) Replace cookbox components.
ANNUAL MAINTENANCE
5 | 9 |
|
10
6
7
|
|
|
|
|
8 |
| 11 |
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
12
13
32WWW.WEBER.COM®
