Weider 16.8ST manual Align Corners Bracket 103

45.Attach the upper end of the Shroud (56) to the two ÒLÓ-brackets on the Top Frame (1) with two 1/4Ó x 3/4Ó Bolts (17), two 1/4Ó Flat Washers (71), and two 1/4Ó Nylon Locknuts (25). Make sure that the indicated corner of the Shroud is lined up with the indicated corner of the Top Frame. The Bolts must be inserted through the square holes in the Shroud. Do not tighten the Bolts yet.

46.Attach the lower end of the Shroud (56) to the bracket on the Stabilizer (5) with four #8 x 3/4Ó Screws (32). The Screws must be inserted through the square holes in the Shroud and into the Tinnerman Clips (38).

Tighten the bolts used in step 45.

47.Insert a 1Ó Round Inner Cap (103) into each end of the Lat Bar (61).

48.Attach the Curl Pad (21) to the Curl Post (83) with four 1/4Ó x 3/4Ó Bolts (17).

49.Make sure that all parts have been properly tight- ened. The use of the remaining parts will be explained in ADJUSTMENT, beginning on page 22 of this manual.

Before using the training system, pull each cable a few times to make sure that the cables move smooth- ly over the pulleys. If one of the cables does not move smoothly, find and correct the problem.

45	1
ÒLÓ-Brackets
		17
		71
Align		71
Corners	17
		25
	56
46
	38
38		32
5	Bracket
		32
	32	56
47
		61
103
		103
48
17		21
		83

IMPORTANT: If the cables are not properly installed, they may be damaged when heavy weight is used. If there is any slack in the cables, you will need to remove the slack by tightening the cables. See TROU- BLE-SHOOTING AND MAINTENANCE on page 24.

20