Weider 831.150470 Align one set of holes in the Adjustment Bracket, Lubricate-11, Guide, Tube

3.Press 20mm x 40mm Inner Caps (44) into the ends of both Backrest Tubes (25).

Lubricate an M10 x 152mm Bolt (11). Attach the Backrest Tubes (25) to the Bench Frame (49) with the Bolt, two M10 Washers (15), and an M10 Nylon Locknut (14). The Backrest Brackets must be ori- ented as shown. Do not overtighten the Nylon Locknut; the Backrest Brackets must be able to move freely.

4.Slide the Adjustment Bracket (26) onto the Bench Frame (49). See the inset drawing. The guide rod inside the Adjustment Bracket must be on the indi- cated side of the welded tube in the Bench Frame.

Align one set of holes in the Adjustment Bracket

(26)with the hole in the Bench Frame (49). Insert the “L” Pin (46) through the Adjustment Bracket and the Bench Frame.

Lubricate an M10 x 152mm Bolt (11). Attach the Adjustment Bracket (26) to the Backrest Tubes (25) with the Bolt, two Adjustment Bracket Spacers (50), and an M10 Nylon Locknut (14). Do not overtight- en the Nylon Locknut; the Backrest Brackets and Adjustment Bracket must be able to move freely.

5.Attach the Backrest (29) to the Backrest Tubes (25) with four M6 x 48mm Screws (35) and four M6 Washers (42).

6.Attach the Seat (34) to the Bench Frame (49) with the M6 x 60mm Screw (16), two M6 x 16mm Screws (17), and three M6 Washers (42).

7

3				44
	15
	14	15	25
			11—Lubricate
	44
		49
4	Lubricate—11		Guide
	14		Rod
	25	50		46
			49
			26	Welded
				Tube
	26	49
		46
5
			25
	29
			42
			35
		42
		35
6
	34
	49
			42
	42	17
	16