11. Note: The WEIDER PRO 545 is designed to be |
used with both olympic and standard barbells. If you |
will be using an olympic barbell, assemble the base |
in the wide position, as shown in the main drawing. |
If you will be using a standard barbell, assemble the |
base in the narrow position, as shown in the inset |
drawing. |
Attach each section of the Base (20, 55) to an |
Adjustment “U” Bracket (31) with two M8 x 68mm |
Bolts (8) and two M8 Nylon Locknuts (12). Do not |
tighten the Nylon Locknuts yet. |
12. Slide a Rear Upright (19) onto the indicated M8 x |
11
20
20
31
8
8
55
31
12
12
8
8 55
58mm Carriage Bolts (6) in either section of the |
Base (20, 55). The Rear Upright must be oriented |
as shown, with the indicated holes facing for- |
ward. A second person must hold the Upright at |
the location shown during the step. Partially |
tighten an M8 Nylon Locknut (12) onto each |
Carriage Bolt but do not fully tighten the Nylon |
Locknut. Note: The heads of the Carriage Bolts |
must lock into the square holes in each section |
of the Base in order to tighten the Nylon |
Locknuts; you may need to slide your fingers |
under the Base to hold the Carriage Bolts in |
place while you partially tighten the Nylon |
Locknuts. |
Assemble the other Rear Upright (19) in the same |
manner. |
13.Press 1” Round Inner Caps (41) into the ends of the Weight Rests (37).
12
A second person must hold each Upright here while the Nylon Locknuts are attached
19
| 19 |
| These holes |
12 | must face |
forward | |
| 12 |
6 | 20 |
| 55 |
6
13
41
37
41
9
