Weider 831.159720 user manual

19.Wrap the Medium Cable (72) over a 4 1/2” Pulley

(34)in the direction shown. Attach the Pulley to the Butterfly Top Frame (64) with a 3/8” x 1 3/4” Bolt (22) and a 3/8” Nylon Locknut (4).

20.Attach the threaded shaft on the Medium Cable (72) to the Small “U”-Bracket (43) with a 1/4” Flat Washer (11) and a 1/4” Nylon Locknut (16). Note: See the inset drawing. Do not completely tighten the Nylon Locknut; it should be threaded only two turns onto the end of the Cable.

Attach the Small “U”-Bracket (43) to the hole in the Weight Tube (77) with a 5/16” x 1 3/4” Bolt (9), and a 5/16” Nylon Locknut (2).

21.Identify the Long Cable (73). It is approximately 299.25” long and it has a ball on one end and a loop on the other. Route the end with the loop through the slot in the cable guide on the Butterfly Base (61).

Route the Long Cable (73) under a 3 1/2” Pulley (5) as shown. Attach the Pulley and a Cable Trap (39) to the indicated bracket on the Butterfly Base (61) with a 3/8” x 2” Bolt (35) and a 3/8” Nylon Locknut (4). Make sure the Cable Trap is oriented as shown.

19
64
22	34	4
72
20
		72
	43	2
	11	9
	16
		77	72
			11	16
			43
21
			61
	4
Cable
Guide			5
73		39	35

12