25.Note: For clarity, this and the following drawings show some parts removed.
Remove the lower 3 1/2” Pulley (5) from the Double “U” Bracket (36). Then, wrap the Long Cable (73) over the Pulley (5) in the direction shown. Attach the Pulley to the Double “U” Bracket (36) with a 3/8” x 1 3/4” Bolt (22) and a 3/8” Nylon Locknut (4). Make sure the Double “U” Bracket is oriented as shown.
26.Wrap the Long Cable (73) around a 3 1/2” Pulley (5) in the direction shown. Attach the Pulley and a Cable Trap (39) to the indicated bracket on the Press Base (60) with a 3/8” x 2” Bolt (35) and a 3/8” Nylon Locknut (4). Make sure the Cable Trap is oriented as shown.
27.Attach a 3 1/2” Pulley (5) and a Cable Trap (39) to the Press Frame Upright (59) with a 3/8” x 4 3/4” Bolt
Wrap the Long Cable (73) around the 3 1/2” Pulley
(5)in the direction shown. Hand tighten a 3/8” Nylon Locknut (4) two turns onto the 3/8” x 4 3/4” Bolt. In step 31, another Pulley will be attached to the Bolt.
28.Route the Long Cable (73) through the opening in the Press Frame (53) and wrap the Long Cable around a 3 1/2” Pulley (5) in the direction shown. Then, route the Long Cable back through the opening in the Press Frame.
Attach the 3 1/2” Pulley (5) and a Cable Trap (39) to the indicated hole in the Press Frame (53) with a 3/8” x 3 1/4” Bolt (28), a 3/8” Flat Washer (17), and a 3/8” Nylon Locknut (4). Make sure the Pulley is mount- ed on the inside of the Press Frame (53). Make sure the Cable Trap is oriented as shown.
25 |
|
|
|
|
36 |
| 4 |
|
|
|
|
|
| |
22 |
|
|
|
|
|
| 5 |
|
|
|
| 73 |
|
|
26 | 73 |
|
| |
|
|
| ||
| 5 | 35 |
|
|
39 |
|
|
|
|
4 |
|
|
|
|
| 60 |
|
| |
27 |
|
|
|
|
|
| 59 |
|
|
|
|
|
| 73 |
|
| 5 | 23 | |
|
|
| ||
|
|
| 39 |
|
4 |
|
|
|
|
28 |
|
|
|
|
73 | 39 | 53 | 17 | 28 |
4 | 5 |
|
|
|
14