21.Attach the indicated end of the Low Cable (8) to the bracket on the Rear Base (3) using an M10 x 20mm Bolt (26) and an M10 Nylon Locknut (11).
22.Press a 50mm Square Inner Cap (10) into the indi- cated end of the Front Leg (73). Insert a 50mm Square Inner Cap (10) into the bottom of the Front Leg.
Attach the Front Leg (73) to the Bench Frame (63) using two M10 x 65mm Bolts (56), two M10 Small Washers (6), and two M10 Nylon Locknuts (11).
Insert the Backrest Knob (80) into the Bench Frame (63) and tighten.
23.Press a 50mm x 70mm Outer Cap (60) onto each end of the Stabilizer (87). Attach the Stabilizer to the Bench Frame (63) using two M10 x 60mm Carriage Bolts (64) and two M10 Nylon Locknuts (11).
Note: The dents on the Stabilizer (87) should face the floor, and the decal should be in the indicated location.
21 |
|
|
|
|
| 8 |
|
|
| Bracket |
|
|
|
| 3 |
|
|
| 11 |
|
| 26 |
|
22 |
|
|
|
|
| 80 |
|
|
| 56 |
|
| 6 | 63 |
|
|
|
| |
|
| 56 |
|
11 |
| 73 |
|
| 10 | 10 |
|
|
|
| |
23 |
| 63 | 11 |
|
|
| |
|
| 60 | 87 |
|
| 64 | 60 |
|
| Decal | |
12
