Weider WEEVSY87210 Frame Assembly, Following Tools not Included are Required for Assembly

ASSEMBLY

Before beginning assembly, carefully read the following information and instructions:

•Place all parts of the weight system in a cleared area and remove the packing materials; do not dispose of the packing materials until assembly is completed.

•The assembly is divided into four stages: 1) frame assembly, 2) arm assembly, 3) cable assembly, and 4) seat assembly. The hardware for each stage is packaged separately.

•Wait until you begin each assembly stage to open that parts bag.

•For help identifying the small parts used in assembly, use the PART IDENTIFICATION

CHART located in the centre of this manual. Note: Some small parts may have been pre- attached for shipping. If a part is not in the parts bag, check to see if it has been pre-attached.

•As you assemble the weight system, be sure that all parts are oriented as shown in the drawings.

•Tighten all parts as you assemble them, unless instructed to do otherwise.

THE FOLLOWING TOOLS (NOT INCLUDED) ARE REQUIRED FOR ASSEMBLY:

• two adjustable spanners

• one standard screwdriver

• one phillips screwdriver

• one rubber mallet

•lubricant, such as grease or petroleum jelly, and soapy water will also be needed.

Assembly will be more convenient if you have the following tools: a socket set, a set of open-end or closed-end spanners, or a set of ratchet spanners.

FRAME ASSEMBLY

1.Before beginning assembly, be sure that you have read and understand the infor- mation in the box above.

Press a 2” Square Outer Cap (51) onto each end of the Stabiliser (5). Press a 2” Square Inner Cap (27) into the end of the Base (4).

Turn the Stabiliser (5) so that the long side is positioned as shown.

Insert two 5/16” x 2 3/4” Carriage Bolts (14) up through the Stabiliser (5). Insert a 5/16” x 2 1/2” Carriage Bolt (1) up through the remaining hole in the Stabiliser. Insert two 5/16” x 2 1/2” Carriage Bolts up through the Base (4).

Slide the indicated end of the Base (4) onto the 5/16” x 2 3/4” Carriage Bolts (14) in the Stabiliser (5). Slide the Rear Upright (56) onto the Carriage Bolts. The high side of the bracket on the Rear Upright must be on the side shown. Hand tighten a 5/16” Nylon Locknut (3) onto each Carriage Bolt.

Do not tighten the Nylon Locknuts yet.

Wet the handles on the Rear Upright (56) with soapy water. Slide a 5” Plastic Hand Grip (31) onto each handle.

1
	High Side of
	Bracket
31	Handles
	56
	51
3
5	Long Side
	4
51	14
	1
	1
	27

5