Weider WESY19001 user manual Cable Assembly

CABLE ASSEMBLY

27. Route the Long Cable (69) behind the Press	27
Frame (17) and under the Seat Frame (36) as
		36			75
shown. Route the Long Cable (69) around
two 3 1/2” Pulleys (15).
Slide the 3/8” x 5” Bolt (75) through the 3 1/2”					15
Pulleys (15), two Cable Traps (66), and the
Press Frame (17) as shown. Tighten a 3/8”			66
Nylon Locknut (21) onto the Bolt. Do not
overtighten the Nylon Locknut; the Pulleys	21		17
must be able to pivot freely.	15	69
28. Locate the section of the Long Cable (69)	28		36
between the two 3 1/2” Pulleys (15) attached		21
			9
in step 27. Route this section of the Long
Cable around a “V”-Pulley (6). Hold a Cable
Trap (66) against the “V”-Pulley to keep the		66
Cable in the groove of the Pulley.
		6
Attach the “V”-Pulley (6) and the Cable Trap		69
(66) to the second hole from the front of the					15
		8
Seat Frame (36) using a 3/8” x 3 1/4” Bolt (8),
a 3/8” Flat Washer (9), and a 3/8” Nylon
Locknut (21). Do not overtighten the Nylon
Locknut; the Pulley must be able to turn
freely.
29. Route the Long Cable (69) around a 3 1/2”	29
Pulley (15). Hold a Cable Trap (66) against
the Pulley to hold the Long Cable in place.			15	64
Attach the 3 1/2” Pulley (15) and the Cable
Trap (66) to the Front Upright (42) using a
3/8” x 4 1/4” Bolt (64), a 3/8” Flat Washer (9),		66
and a 3/8” Nylon Locknut (21). Do not over-
tighten the Nylon Locknut; the Pulley must	21
be able to turn freely.
	9
		42			69
30. Attach the end of the Long Cable (69) to the	30
Leg Lever (29) using a 3/8” x 2 3/4” Bolt (85),
a 5/8” x 1/2” Spacer (82), two 3/8” Flat
Washers (9), and a 3/8” Nylon Jamnut (67).				29	85
		67			69
					82
				9
		9

15