Weider WESY19002 user manual ARM Assembly Cable Assembly, Indicated bracket on the Top Frame

ARM ASSEMBLY

CABLE ASSEMBLY

15. Press a 1 3/4” Square Inner Cap (44) into the	15
lower end of the Left Arm (47). Using a small
amount of soapy water, slide a Large Foam
Pad (45) onto the Left Arm.
Assemble the Right Arm (48, not shown) in
the same manner.
				45
		47
				44
16. Lubricate both axles on the Top Frame (55).	16	55
Slide the Right Arm (48) onto the right axle.
Note: Be careful not to confuse the Right			47
Arm with the Left Arm (47). Make sure that
the upper end of the Right Arm is behind	Lubricate		Bracket
the indicated bracket on the Top Frame (55).
	Axle	68
Tap two 1” Retainers (68) and a 1” Round
Outer Cap (65) onto the right axle. Make sure		65
the teeth on the Retainers bend toward the
Round Outer Cap, as shown in the inset			68
drawing.		48
Attach the Left Arm (47) in the same manner.			65
17. Important: As you assemble the cables in	17
steps 17–30, refer to the CABLE DIAGRAM
			23	8
on page 21 for correct cable routing.	6
Route the Short Cable (23) up through the	55
hole in the Top Frame (55) as shown. Make				9
sure the ball is on the indicated side. Attach a				82
“V”-Pulley (6)to the hole in the Top Frame
using a 3/8” x 3 1/4” Bolt (8), two 3/8” Washers
(9), two 5/8” x 1/2” Spacers (82), and a 3/8”
Nylon Locknut (21) as shown. Do not over-
tighten the Nylon Locknut; the Pulley must		82	Ball
be able to turn freely.
	21	9
18. Route the Short Cable (23) around another	18
“V”-Pulley (6). Hold a Long Cable Trap (50)
	50		76
against the Pulley so that it secures the Short
	55
Cable in the groove of the Pulley.			6
			23
Attach the “V”-Pulley (6) and the Long Cable
Trap (50) to the bracket (not shown) on the
Top Frame (55) using a 3/8” x 2 1/4” Bolt (76)
and a 3/8” Nylon Jamnut (67).Do not over-	67
tighten the Nylon Jamnut; the Pulley must
be able to turn freely.

12