Weider WESY19610 user manual Cable Assembly

CABLE ASSEMBLY	14
	23
14. During steps 15 through 44, refer to the CABLE		121”
DIAGRAMS on page 23 of this manual to verify
proper cable routing. Before beginning this sec-	19
tion, identify the High Cable (23), the Low Cable
		161”
(19), the Press Cable (58), and the Resistance
Cable (27) by comparing the ends and lengths of	58
the cables. IMPORTANT: While assembling the
		116 1/2”
cables, do not overtighten the bolts and nuts
securing the pulleys; the pulleys must be able	27
to turn freely.
		148”
15. Identify the High Cable (23). Wrap the High	15
Cable around a 3 1/2” Pulley (15). Attach the
Pulley to the Top Frame (55) with a 3/8” x 3 3/4”		71
Bolt (71) and a 3/8” Nylon Locknut (21). Make
		23
sure that the end of the Cable with the ball is	55
on the indicated side of the Pulley and that		Ball
the Cable is between the Pulley and the hook
(not shown).
		15
	21	Hook
16. Wrap the High Cable (23) around a “V”-Pulley (6).	16
Attach the Pulley and a Long Cable Trap (50) to		7
	50
the top bracket on the Front Upright (42) with a
3/8” x 2 1/2” Bolt (7) and a 3/8” Nylon Locknut
(21). Make sure that the Cable Trap is posi-		6
tioned to hold the Cable in place.		23
	42
	21
17. Route the High Cable (23) around the “V”-Pulley	17
(6) on the Left Arm (47) and then around the “V”-
Pulley on the Right Arm (48). Make sure that the
Cable is in the grooves of the Pulleys and that		47
the Long Cable Traps (not shown) are posi-
tioned to hold the Cable in place. Properly
tighten the 3/8” x 2 1/2” Bolts (not shown) and the
3/8” Nylon Locknuts (not shown) attaching the	23
“V”-Pulleys.
		6
	48
	10